DOCUMENT:Q129042  08-AUG-2001  [winnt]
TITLE   :Alternate Methods of Booting from a Failed Mirror
PRODUCT :Microsoft Windows NT
PROD/VER:3.50
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows NT Server version 3.5 
-------------------------------------------------------------------------------

If the primary or boot drive is mirrored and fails, the following alternate
method can be used to boot from the mirrored drive if there is no fault
tolerant boot floppy available. This procedure applies only if the boot
partition is mirrored. You need MS-DOS FDISK.EXE or Norton Utilities
DISKEDIT.EXE. This method works only fox x86-based platforms.

1. Remove the power cable from the failed primary drive.

2. Boot from drive A.

3. To use FDISK:

   a. Start FDISK. Make sure you have Fixed Disk Drive 1 selected.

   b. Select option 2, Set Active Partition.

   c. Press 1 when you are prompted to enter the number of the partition you
      want to make active. Enter 1.

   d. When the Partition 1 Made Active message appears, press Esc. FDISK reboots
      the system.

   To use DISKEDIT:

   a. From the Object menu, choose Drive.

   b. Select physical disks, hard disk 1.

   This shows the MBR on the disk.

   c. Go to offset 446.

   d. This byte will be set to 00, change it to 80.

   e. From the Edit menu select Write changes and then select Write.

   f. Quit DISKEDIT.

You should now be able to boot from the hard disk.

NOTE: The specified offset for the boot indicator assumes that the first
physical partition table entry contains the system partition. This may not
always be the case. Some computers, such as Compaq, may have an EISA
configuration or other partition not used by the operating system as the
first physical partition. The system partition has the files NTLDR,
NTDETECT.COM and BOOT.INI. This is the partition that should be marked
active. The correct offset can be calculated by adding 16 for the next
partition table entry or using the table below.

Boot Indicator for Partition 1  =  446  - Hex 01BE

Boot Indicator for Partition 2  =  462  - Hex 01CE

Boot Indicator for Partition 3  =  478  - Hex 01DE

Boot Indicator for Partition 4  =  494  - Hex 01EE

Additional query words: prodnt drive ft
======================================================================
Keywords          :  
Technology        : kbWinNTsearch kbWinNT350search kbWinNTSsearch kbWinNTS350 kbWinNTS350search
Version           : 3.50

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2001.