ECO NUMBER: ALPCPU1A02_062 PRODUCT: OpenVMS Alpha OPERATING SYSTEM 6.2 UPDATE PRODUCT: OpenVMS Alpha OPERATING SYSTEM 6.2 COVER LETTER 1 KIT NAME: ALPCPU1A02_062 2 KITS SUPERSEDED BY THIS KIT: ALPCPU1A01_062 3 KIT DEPENDENCIES: 3.1 The following remedial kit(s) must be installed BEFORE installation of this, or any required kit: None. 3.2 In order to receive all the corrections listed in this kit, the following remedial kits should also be installed: ALPLAN05_062 - For RACORE and DE500-BA adapter support 4 KIT DESCRIPTION: 4.1 Version(s) of OpenVMS to which this kit may be applied: OpenVMS Alpha V6.2, V6.2-1H1, V6.2-1H2, V6.2-1H3 4.2 Files patched or replaced: o [SYS$LDR]SYS$CPU_ROUTINES_1A05.EXE (new image) 5 PROBLEMS ADDRESSED IN ALPCPU1A02_062 KIT o Indexing was changed to zero-based so that array indexing will start with [0], [1], etc. not [1], [2], etc. The C language uses zero-based indexing. o A backport for OpenVMS V6.2-1H3 was done to change some definitions to unsigned long, so that the error log will not be passed over. Specifically, the error_time_threshold value was corrected because the threshold value was previously too large. -- COVER LETTER -- Page 2 19 January 1999 6 PROBLEMS ADDRESSED IN ALPCPU1A01_062 KIT o Add support for the DE500-BA adapter and the Gigabit Ethernet adapter. o The RACORE (Token Ring) adapter was never supported in V6.2. Since the supported adapter, a Thomas Conrad (Token Ring adapter), is being phased out, this new adapter must now be supported. 7 KIT INSTALLATION RATING: The following kit installation rating, based upon current CLD information, is provided to serve as a guide to which customers should apply this remedial kit. (Reference attached Disclaimer of Warranty and Limitation of Liability Statement) INSTALLATION RATING: INSTALL_2 : To be installed by all customers using the following feature(s): RACORE (Token Ring) adapter and/or DE500-BA adapter and/or the new Alpha 21264 system 8 INSTALLATION INSTRUCTIONS: Install this kit with the VMSINSTAL utility by logging into the SYSTEM account, and typing the following at the DCL prompt: @SYS$UPDATE:VMSINSTAL ALPCPU1A02_062 [location of the saveset] The saveset location may be a tape drive, or a disk directory that contains the kit saveset. The images in this kit will not take effect until the system is rebooted. If you have other nodes in your VMS cluster, they must also be rebooted in order to make use of the new image(s). If it is not possible or convenient to reboot the entire cluster at this time, a rolling re-boot may be performed. Copyright (c) Compaq Computer Corporation, 1998 All Rights Reserved. Unpublished rights reserved under the copyright laws of the United States. The software contained on this media is proprietary to and embodies the confidential technology of Compaq Computer Corporation. Possession, use, or dissemination of the software and media is -- COVER LETTER -- Page 3 19 January 1999 authorized only pursuant to a valid written license from Compaq Computer Corporation. DISCLAIMER OF WARRANTY AND LIMITATION OF LIABILITY THIS PATCH IS PROVIDED AS IS, WITHOUT WARRANTY OF ANY KIND. ALL EXPRESS OR IMPLIED CONDITIONS, REPRESENTATIONS AND WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, OR NON-INFRINGEMENT, ARE HEREBY EXCLUDED TO THE EXTENT PERMITTED BY APPLICABLE LAW. IN NO EVENT WILL COMPAQ BE LIABLE FOR ANY LOST REVENUE OR PROFIT, OR FOR SPECIAL, INDIRECT, CONSEQUENTIAL, INCIDENTAL OR PUNITIVE DAMAGES, HOWEVER CAUSED AND REGARDLESS OF THE THEORY OF LIABILITY, WITH RESPECT TO ANY PATCH MADE AVAILABLE HERE OR TO THE USE OF SUCH PATCH.