HP Services Software Patches - nisfix-2-040

 
NOTE:  An OpenVMS saveset or PCSI installation file is stored
       on the Internet in a self-expanding compressed file.
       The name of the compressed file will be kit_name-dcx_vaxexe
       for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
 
       Once the file is copied to your system, it can be expanded
       by typing RUN compressed_file.  The resultant file will
       be the OpenVMS saveset or PCSI installation file which
       can be used to install the ECO.
 
Copyright (c) Digital Equipment Corporation 1997.  All rights reserved.

PRODUCT:    DEC Network Integration Server Software

OP/SYS:     OpenVMS VAX

COMPONENT:  DECnet/OSI for OpenVMS VAX

SOURCE:     Digital Equipment Corporation

ECO INFORMATION:

     ECO Kit Name:  NISFIX-2-040
     ECO Kits Superseded by This ECO Kit:  None 
     ECO Kit Approximate Size:  129,723 Blocks
                    Saveset A -     315 Blocks
                    Saveset B - 129,276 Blocks
                    Saveset C -     126 Blocks
                 Cover Letter -       6 Blocks

     Kit Applies To:  DEC Network Integration Server Software V4.0
                      OpenVMS VAX V6.1, V6.2, V7.0, V7.1
                      DECnet/OSI for OpenVMS VAX V6.1, V6.2, V7.0
                                                 V7.1
     Server Reboot Necessary:  Yes
     Installation Rating:  N/A

     NOTE:  In order to receive the full fixes listed in this kit,
            the following remedial kits also need to be installed:

                 None  


ECO KIT SUMMARY:

An ECO kit exists for DECNIS V4.0 on OpenVMS VAX V6.1 through V7.1.
This is a very brief description of the problems that are addressed
by this kit.  For more in-depth information, please see the Release
Notes that are included in this kit.

Problems Addressed in NISFIX-2-040:

        o W622 packet transmission could crash DECNIS
        o DDCMP link would not restart
        o Corrupt frame could crash DECNIS
        o Fragmentation error messages not sent
        o IPX could be enabled in error over SMDS
        o DECNIS crash on receipt of non pseudo node LSP
        o Reachability lost when running routing vector
        o In the previous release, it was noticed that RIP seemed to
             stop working over a PPP link.
        o Counting to infinity in certain circumstances
        o Occasional decrease in routing performance
        o Setting DECNIS time backwards could lose reachability
        o 3 non-zero VPI values can be used on W631
        o W631 sometimes fails to load
        o Loss of reachability to IPX servers
        o X.25 allowed access to blocked nodes
        o Loss of access to load file caused crash
        o BOOTP replies not forwarded on circuit 0.0.0.0
        o Degradation of bridge performance between DLCIs
        o Odd length packets not bridged to routeabout
        o PPP or VCP circuit down could crash DECNIS
        o Degradation of bridge performance between DLCIs


INSTALLATION NOTES:

The system/cluster does not need to be rebooted after this kit is 
installed.  However, the affected servers should be rebooted 
in order for all kit changes to take effect.     

Files on this server are as follows:

»nisfix-2-040.README
»nisfix-2-040.CHKSUM
»nisfix-2-040.CVRLET_TXT
»nisfix-2-040.a-dcx_vaxexe
»nisfix-2-040.b-dcx_vaxexe
»nisfix-2-040.c-dcx_vaxexe