ECO NUMBER: VAXLAVC01_2H4055 ----------- PRODUCT: OpenVMS VAX Operating System -------- UPDATED PRODUCT: OpenVMS VAX Operating System 5.5-2 ---------------- APPRX BLCK SIZE: 198 ---------------- UPDATE PRODUCT: OpenVMS VAX OPERATING SYSTEM 5.5-2H4 COVER LETTER 1 KIT NAME: VAXLAVC01_2H4055 2 KITS SUPERSEDED BY THIS KIT: None. 3 KIT DESCRIPTION: 3.1 Version(s) of OpenVMS to which this kit may be applied: OpenVMS VAX V5.5-2H4 3.2 In order to receive the full fixes listed in this kit the following remedial kits also need to be installed: None. 3.3 Files patched or replaced: o [SYS$LDR]PEDRIVER.EXE (new image) o [SYSEXE]PEDRIVER.STB (new file) 4 PROBLEMS ADDRESSED IN VAXLAVC01_2H4055 KIT o Nodes in a LAVC may cluexit in mixed Enet/FDDI environments where duplicate hello messages are being produced (i.e. out-of-rev bridge firmware). This problem is corrected in OpenVMS VAX V7.0. 5 INSTALLATION INSTRUCTIONS: Install this kit with the VMSINSTAL utility by logging into the SYSTEM account, and typing the following at the DCL prompt: @SYS$UPDATE:VMSINSTAL VAXLAVC01_2H4055 [location of the saveset] The saveset location may be a tape drive, or a disk directory that contains the kit saveset. -- COVER LETTER -- Page 2 23 September 1996 System should be rebooted after successful installation of the kit. If you have other nodes in your VAXcluster, they should also be rebooted in order to make use of the new image(s). Copyright (c) Digital Equipment Corporation, 1996 All Rights Reserved. Unpublished rights reserved under the copyright laws of the United States. The software contained on this media is proprietary to and embodies the confidential technology of Digital Equipment Corporation. Possession, use, duplication, or dissemination of the software and media is authorized only pursuant to a valid written license from Digital Equipment Corporation.