|
|
 |
SNA_PRE SNAPRE_E01014 DIGITAL SNA Printer Emulator OpenVMS ECO Summary
|
TITLE: SNA_PRE SNAPRE_E01014 DIGITAL SNA Printer Emulator OpenVMS ECO Summary
********************** NOTE *********************
* *
* Engineering is currently researching a problem *
* with this ECO and requested that it be placed *
* on hold. *
* *
***************************************************
Modification Date: 11-JUN-99
Modification Type: Kit Placed on Engineering Hold.
NOTE: An OpenVMS saveset or PCSI installation file is stored
on the Internet in a self-expanding compressed file.
The name of the compressed file will be kit_name-dcx_vaxexe
for OpenVMS VAX or kit_name-dcx_axpexe for OpenVMS Alpha.
Once the file is copied to your system, it can be expanded
by typing RUN compressed_file. The resultant file will
be the OpenVMS saveset or PCSI installation file which
can be used to install the ECO.
Copyright (c) Compaq Computer Corporation 1999. All rights reserved.
PRODUCT: DECnet SNA Printer Emulator for OpenVMS
OP/SYS: OpenVMS VAX
OpenVMS Alpha
SOURCE: Compaq Computer Corporation
ECO INFORMATION:
ECO Kit Name: SNAPRE_E01014
ECO Kits Superseded by This ECO Kit: None
ECO Kit Approximate Size: 2088 Blocks
Kit Applies To: DECnet SNA Printer Emulator for OpenVMS V1.4
OpenVMS VAX V6.2, V7.0, V7.1, V7.2
OpenVMS Alpha V6.2, V6.2-1H1, V6.2-1H2, V6.2-1H3,
V7.0, V7.1, V7.1-1H1, V7.1-1H2,
V7.1-2, V7.2
System/Cluster Reboot Necessary: No
Rolling Re-boot Supported: Not Applicable
Installation Rating: INSTALL_UNKNOWN
This information is not available
Kit Dependencies:
The following remedial kit(s) must be installed BEFORE
installation of this kit:
None
In order to receive all the corrections listed in this
kit, the following remedial kits should also be installed:
None
ECO KIT SUMMARY:
An ECO kit exists for SNA PRE V1.4 on OpenVMS V6.2 through V7.2.
Problems Addressed in the SNAPRE_E01014 Kit:
o Local OpenVMS Alpha users can now connect to Compaq SNA Server
without using a network connection. This is similar to OpenVMS
VAX local users connections to VMS/SNA. Example: $SET HOST/SNA 0.
o Fixed a problem where the connection failed to a gateway
because the terminal ID was longer than 32 bytes. The
following error was returned:
%SNA-E-INVTRMPAR, invalid authterm parameter
-SNA-E-LENTOOLON, transmit byte count exceeds buffer length
This problem would only occur while logged into a terminal
that is TELNETed from another system and the access is to a
PU2 gateway or VMS/SNA through GAS.
INSTALLATION NOTES:
The system/cluster does not need to be rebooted after this kit is
installed.
The ECO kit checks to ensure that a valid license is installed before
proceeding. If one is not found, the installation aborts.
All trademarks are the property of their respective owners.
|
Files on this server are as follows:
|
»snapre_e01014.README
».CHKSUM
»snapre_e01014.a-dcx_axpexe
»snapre_e01014.a-dcx_vaxexe
»snapre_e01014.CVRLET_
|
