General
-------
1. Server abend if transmissions were still pending when AURP unloaded.
Now waits up to five minutes for transmissions to complete before unloading.
2. Server abend because ADSP released an invalid memory resource.
3. IPXRTRNM abend.
4. IPXCON did not display a level 2 neighbor.
5. IPXCFG did not set the frame type incorrectly for IPX if the default was
not selected.
AppleTalk
---------
6. Hung or aborted print jobs for applications using the AppleTalk 3.x
APIs.
7. Possible invalid DDP checksum of 0xFFFF transmitted when DDP checksums are enabled.
TCP/IP
------
8. Directed broadcasts forwarded in only one direction.
9. Depending on the order in which the filters were set, a route filter
exception could be ignored.
10. A possible page fault if a TCP or UDP stream is aborted while data is
in transmission.
11. A race condition that might cause an abend when running SFT III on a
large IP internet.
IPXRTR
------
12. The SAP from a print server was not aged out if RIP and SAP were
operating in AUTO mode.
13. Wildcard filters were applied inappropriately to the source of the
packet to all interfaces.
14. Even with SET REPLY TO GET NEAREST SERVER option was off, Get Nearest Server requests resulted in a response from the nearest Directory Server.
15. Load Balancing not working.
NEW FEATURES
1. Improved error detection when using AppleTalk.
2. Bridging can now work concurrently over X.25 and Frame Relay.
3. INETCFG now has improved conversion of load commands from NetWare for Macintosh to the INETCFG database.
4. LAN Network Manager (LNM) functionality.
5. TCPIP now supports OSPF on SFT III IO Engines. The Autonomous System Boundary Router parameter must be enabled in the OSPF configuration. Use INETCFG to enable and configure OSPF.
6. Routes learned from SNMP will now be advertised by the IP routing
protocol.
7. NLSP can now switch automatically from broadcast to multicast, when all NLSP nodes on the LAN support multicast.
|