Switch Codes for [TCPIP_XIF] Section of PROTOCOL.INI (98462)




This article was previously published under Q98462

SUMMARY

These lines are in the [TCPIP_XIF] section of PROTOCOL.INI: 
   LOAD=TCPTSR[C], TINYRFC[C], EMSBFP[C],TELNET[C], BAPI[CR]
   UNLOAD="UNLOADT /NOTSR[DC]"

Switch codes:

   U - On load: load into upper memory if possible
       on unload: unload from memory
   C - Do not load into upper memory
   B - Bind protocol to hardware
   R - Register protocol with redirector
   D - Deregister protocol with redirector
These switches are not specific to TCP/IP: they are valid for any demand loadable protocol. The lines for other protocols are very similar to the ones shown above.
Modification Type: Major Last Reviewed: 7/30/2001
Keywords: KB98462
©2002 Microsoft Corporation. All rights reserved.