SUMMARY
This document describes the configuration file settings required for
using the MSDLC transport with a Windows for Workgroups 3.1 client. It
is for systems in which NetBEUI is the only protocol installed. If TCP/IP
is already installed, the value associated with the LANA may not be 0.
The installation is covered in Microsoft Technical Note Volume 3, Number
33, included with LAN Manager 2.2.)
Once MSDLC is installed, edit the files listed below to make the changes
described:
AUTOEXEC.BAT
Insert the following line before the "net start" line:
C:\WINDOWS\PROTOCOL.INI
Insert the following line after the last transport line:
Insert the following line after the last lana line:
(Replace "ms$elnkii" with the correct adapter driver name.)
Insert the following section at the end of the file:
[MSDLC]
DriverName=MSDLC$
Usedix=0
Swap=1
Bindings=adapter_name
Lanabase=0
On Ethernet networks only, add:
Usedix = 0 for Ethernet DIX 2.0 format
Usedix = 1 for 802.3 frame format
Swap = 0 (do not bit-swap Ethernet address)
= 1 (bit-swap Ethernet address)
C:\WINDOWS\SYSTEM.INI
Add the following line to the [386Enh] section:
Add the following line to the [network] section:
The above changes take effect when you restart the system.