PRB: Problems Using SET PRINTER TO \\SPOOLER on Novell Network (95589)


The information in this article applies to:

  • Microsoft Visual FoxPro for Windows 3.0
  • Microsoft Visual FoxPro for Windows 5.0
  • Microsoft Visual FoxPro for Windows 6.0
  • Microsoft FoxPro for MS-DOS 2.0
This article was previously published under Q95589

SYMPTOMS

The following switches to the SET PRINTER TO \\SPOOLER command do not consistently direct the printer setup on a Novell network: 
   \NB               Suppresses the printing of a banner page.
   \F = <expN>       Specifies the form number to print on.
   \B = <banner>     Specifies a banner name.
   \C = <expN>       Specifies the number of copies to be printed.

CAUSE

This problem occurs only with the Novell 3.26 shell or later. Older versions of the software work correctly, but they may produce other problems if you are using Windows. Novell 3.26 or later is the preferred software to use with Windows.

RESOLUTION

These options should be set by using the RUN command to shell out to MS-DOS and then using the Novell CAPTURE command. After printing, you must close the print file and send the print job. To do this, either issue a RUN ENDCAP command or quit FoxPro.

MORE INFORMATION

The Novell network product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.
Modification Type:MajorLast Reviewed:12/1/2003
Keywords:kb3rdparty kbprb KB95589
©2003 Microsoft Corporation. All rights reserved.