X400: Typical Batch Files to Set Up and Start X.400 Gateway (86972)


The information in this article applies to:

  • Microsoft Mail Gateway to X.400 3.0
This article was previously published under Q86972

SUMMARY

The CONFIG.SYS files do not change when either the X.25 Eicon card or the redirector software is installed.

The AUTOEXEC.BAT files may contain the following startup: 
   Server Startup
      nabios srv gateway /4
      ecload
Or, if the workstation is a redirector workstation: 
   Eicon Redirector Software Startup
      nabios rdr gateway /4
      x25net start
A typical X.400 startup batch file appears as follows: 
   x400gate -dq -lv
The Eicon X.25 card installation manual contains additional examples of installation and startup batch files.
Modification Type:MajorLast Reviewed:11/5/1999
Keywords:KB86972
©2002 Microsoft Corporation. All rights reserved.