WRK Flowchart Incorrectly States SMARTDrive Cache (85638)
The information in this article applies to:
- Microsoft Windows 3.1
- Microsoft Windows 3.11
This article was previously published under Q85638 SUMMARY
Page 17, chart 1.8, of the "Microsoft Windows Resource Kit" (WRK) guide for
Windows 3.1 states the following in the fifth flowchart step:
Note: The SMARTDrive command line can be edited to allow caching
of "stacked" volumes by adding a +<drive> (where <drive> is a "stacked"
volume). If caching...
The +<drive> parameter is incorrect. The correct command line syntax to
turn on the SMARTDrive disk cache is as follows:
C:\WINDOWS\SMARTDRV.EXE <drive>+
MORE INFORMATION
SMARTDrive will automatically detect the existence of Stacker and cache the
underlying Stacker drive. SMARTDrive should not be used to cache a Stacker
volume. Typing SMARTDRV /? at the MS-DOS prompt lists the command line
parameters for SMARTDrive with their meaning.
| Modification Type: | Major | Last Reviewed: | 10/14/2003 |
|---|
| Keywords: | KB85638 |
|---|
|