Maintenance Mode Setup of Windows 3.1 and Networks (82724)

MORE INFORMATION

There are several limitations in the Windows version of maintenance mode Setup. In general, Setup should be run from the command prompt outside of Windows when modifying the network configuration.

Although Setup can add entries to the LOAD= line in the WIN.INI file, it cannot remove them. Therefore, when changing from a network that puts a utility on the LOAD= line in the WIN.INI file to a network that provides different network utilities, the first utility installed will continue loading, probably causing an error message. An example is NWPOPUP.EXE in Novell NetWare.

When changing networks, you should remove network utilities from the LOAD= line in the WIN.INI file.

Some networks have Windows components that do not ship with Windows. If these components are found in the network directory during Setup, Setup will configure Windows to use them; otherwise, Setup will use a default installation and notify you of the missing software.

Because the descriptions for these network versions are the same, Setup will not automatically reconfigure Windows to use the components if they are later copied to the machine. To correctly reconfigure Windows to use the added network components, you must run maintenance mode Setup twice; once to set the network to "No Network Installed," and once to set it back to the original network version. Note that maintenance mode Setup does not perform detection. You must know which network entry to select.