WinWord Setup Fails on Disk 2; DRIVPARM Solution (79207)
The information in this article applies to:
- Microsoft Word for Windows 2.0
- Microsoft Word for Windows 2.0a
- Microsoft Word for Windows 2.0b
- Microsoft Word for Windows 2.0c
- Microsoft Word for Windows 6.0
- Microsoft Word for Windows 6.0a
- Microsoft Word for Windows 6.0c
- Microsoft Word for Windows 95
- Microsoft Word 97 for Windows
This article was previously published under Q79207 SYMPTOMS
In Word for Windows, the Setup program fails after you insert Disk 2.
RESOLUTION
You may need to use the MS-DOS DRIVPARM command to correct the problem.
If a physical drive is not reading a disk properly and the disk is not
physically defective, the MS-DOS DRIVPARM command in the CONFIG.SYS
file can often correct the problem. The DRIVPARM command modifies the
parameters of an existing physical drive. It does not create a new
logical drive. The settings specified in the DRIVPARM command override
the driver definitions for any previous block device.
MORE INFORMATION
The DRIVPARM command does not correct any problems reading floppy
disks if the disks are defective. In the case of defective disks,
it is necessary to obtain replacement disks from Microsoft Product
Support Services.
Symptoms of Disk Drive Not Reading Properly
Place a Setup disk (Disk 1) in drive A or drive B, and use the MS-DOS
DIR command to display a directory list of that disk. Switch to Disk
2, and use the MS-DOS DIR command to display a directory of Disk 2. If
you receive another directory list for Disk 1, your logical drive is
reading incorrectly.
DRIVPARM Command and Its Parameters
If the above problem occurs, add the following statement to your
system's CONFIG.SYS file:
drivparm=/d:number /f:factor
"/d:number" specifies the physical drive number.
Values for "number" must be in the range 0 through 255 (/d:0 = drive
A, /d:1 = drive B, /d:2 = drive C, and so on).
"/f:factor" specifies the drive type. The factor numbers for drive
types are as follows:
0 = 160K/180K or 320K/360K
1 = 1.2 megabyte (MB)
2 = 720K (3.5-inch disk)
5 = Hard disk
6 = Tape
7 = 1.44 MB (3.5-inch disk)
8 = Read/write optical disk
9 = 2.88 MB (3.5-inch disk)
Further information for the DRIVPARM command can be found on pages
455-457 of the "Microsoft MS-DOS Operating System version 5.0 User's
Guide and Reference."
For more information on the MS-DOS DRIVPARM command, query on the
following words in the Microsoft Knowledge Base:
drivparm and MS-DOS and 3.3
OTHER WORKAROUNDS
Method 1: Eject Disk 2 and press ENTER. Then reinsert the disk and press ENTER again.
Method 2: When you are prompted to change disks insert disk 2, and use ALT+TAB to change the focus to File Manager (or Program Manager and start File Manager). Select drive A and press F5 to force a refresh. Use ALT+TAB to return the focus to Setup and continue.
REFERENCES
"Microsoft MS-DOS Operating System version 5.0 User's Guide and
Reference," pages 455-457
Modification Type: | Minor | Last Reviewed: | 8/16/2005 |
---|
Keywords: | kbsetup KB79207 |
---|
|