Err Msg: "Error Reading/Writing Drive x" with WD-1006V-SR2 (77771)



The information in this article applies to:

  • Microsoft MS-DOS operating system 5.0
  • Microsoft MS-DOS operating system 5.0a
  • Microsoft MS-DOS operating system 6.0
  • Microsoft MS-DOS operating system 6.2
  • Microsoft MS-DOS operating system 6.21
  • Microsoft MS-DOS operating system 6.22

This article was previously published under Q77771

SYMPTOMS

If you have a Western Digital Controller card model WD-1006v-SR2, you may receive the following error when reading or writing to a floppy disk drive:
Error Reading/Writing Drive A (or Drive B)

CAUSE

Western Digital controller cards (WD-1006V-SR2) dated earlier than 1990 may conflict with the MS-DOS EMM386.EXE memory manager.

WORKAROUND

To eliminate this error, exclude the appropriate address range within the upper memory area (UMA) used by the controller card. To exclude the upper memory range, place the exclusion range on the EMM386.EXE line of the CONFIG.SYS file as follows

DEVICE=<drive>:\<dir>\emm386.exe X=CC00-CDFF

where <drive> and <dir> are the drive and directory in which the EMM386.EXE file is located.

NOTES:
  • If a range other than CC00-CDFF is specified for the controller card, that range should be excluded.
  • If you run MS-DOS MemMaker after you exclude the memory range, choose Custom Setup, and then choose to "Keep current EMM386 memory exclusions and inclusions."

MORE INFORMATION

To test for an upper memory address conflict, remove the EMM386.EXE device line from the CONFIG.SYS file or exclude the full upper memory address range, A000-EFFF.

The Western Digital products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Modification Type:MajorLast Reviewed:5/10/2003
Keywords:KB77771