Enhanced Mode Windows Does Not Reset COM Ports (77563)
The information in this article applies to:
This article was previously published under Q77563 SYMPTOMS
Your communications or modem program runs correctly before starting
Microsoft Windows, but does not run or initialize after enhanced mode
Windows has been run and exited.
CAUSE
Serial ports used by a program in enhanced mode of Microsoft Windows 3.0
may not be reset upon exiting Windows.
RESOLUTION
If this occurs, there are two ways to correct the problem.
- Reboot the computer. This fully resets the serial ports.
-or-
- Run a program specifically written to reset serial ports.
NOTE: There are several shareware and freeware programs written that
perform a COM port reset.
Modification Type: | Minor | Last Reviewed: | 7/19/2005 |
---|
Keywords: | KB77563 |
---|
|