Using Quarterdeck's BUFFERS.COM With MS-DOS 4.0 and Later (76199)



The information in this article applies to:

  • Microsoft MS-DOS operating system 4.0
  • Microsoft MS-DOS operating system 4.01
  • Microsoft MS-DOS operating system 5.0
  • Microsoft MS-DOS operating system 5.0a

This article was previously published under Q76199

SUMMARY

Using the BUFFERS.COM utility from any version Quarterdeck expanded memory manager 386 (QEMM386) before 6.0 with MS-DOS version 4.0 or later will trigger the following error message:
BUFFERS requires DOS version 2 or 3 to run
Support for MS-DOS version 5.0 was added in the 6.0 release of QEMM386. BUFFERS.COM continues to be incompatible with MS-DOS versions 4.00, 4.01 and 4.01a.

MORE INFORMATION

Look-ahead buffers, introduced in MS-DOS 4.0, allow multiple sector processing when sequential data is read from or written to a disk. Quarterdeck BUFFERS.COM does not support this format.

BUFFERS.COM, prior to QEMM version 6.0, is designed to allow users with QEMM and MS-DOS versions earlier than 4.0 to load system buffers out of conventional memory with the following line in the AUTOEXEC.BAT file:
   loadhi buffers=##
				
This loads the disk buffers into High RAM, also known as Upper Memory Blocks. Buffers created with BUFFERS.COM are in addition to buffers allocated via the BUFFERS= statement in CONFIG.SYS.

With the 6.0 release of QEMM, support for MS-DOS 5.0 was added to BUFFERS.COM and buffers can be loaded high through the AUTOEXEC.BAT in the manner listed above. However, there is less need to use BUFFERS.COM with MS-DOS 5.0 as up to 48 disk buffers can be loaded into the high memory area (HMA) when MS-DOS is loaded high. For example, the following lines in the CONFIG.SYS file will allocate 20 buffers which load with MS-DOS into the HMA:
   device=c:\qemm\qemm386.sys
   dos=high
   buffers=20
				
If more than 48 buffers are in specified using BUFFERS=, all of the buffers allocated by BUFFERS= will be loaded into conventional memory.

Although all versions of BUFFERS.COM continue to be incompatible with MS-DOS versions 4.0, 4.01, and 4.01a, buffers can be loaded into expanded memory (when present) by adding /X to the end of the buffers line in the CONFIG.SYS file. For example, the line below loads 20 disk buffers into expanded memory:
   buffers=20 /x
				
The product included here is manufactured by vendors independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

Reference(s):

"Quarterdeck expanded memory manager 386," version 5.0 pages 43-44. "Quarterdeck expanded memory manager 386," version 6.0 page 67.

Modification Type:MajorLast Reviewed:10/20/2003
Keywords:KB76199