Plus Hardcard II Is Very Slow with EMM386 (74451)



The information in this article applies to:

  • Microsoft MS-DOS operating system 5.0
  • Microsoft MS-DOS operating system 5.0a
  • Microsoft MS-DOS operating system 6.0

This article was previously published under Q74451

SUMMARY

The Plus Hardcard II may be extremely slow when used with EMM386. The following information, which applies to Microsoft MS-DOS version 5.0, could help correct this problem.

MORE INFORMATION

With the use of EMM386.EXE:

  1. Exclude the Hardcard XL BIOS address. For example:
          Device=c:\dos\EMM386.EXE X=C000-C800
    						
    (These specific numbers are only examples for the purpose of syntax. The exact addresses to exclude will depend on your configuration. Please see your Hardcard documentation.)
  2. If you are not using UMBs, use the frame= parameter to set the address of the page frame such that the page frame will not conflict with the addresses being used by the Hardcard. For example, if the Hardcard is using addresses C000-C800, you might use:
          Device=c:\dos\EMM386.EXE frame=D000
    						
    This sets the page frame for the D000-DFFF range of memory.

Modification Type:MajorLast Reviewed:10/13/2003
Keywords:KB74451