Debug: "U 0 FFFF" Produces Incorrect Results (70749)
The information in this article applies to:
- Microsoft MS-DOS operating system 2.11
- Microsoft MS-DOS operating system 3.1
- Microsoft MS-DOS operating system 3.2
- Microsoft MS-DOS operating system 3.21
- Microsoft MS-DOS operating system 3.3
- Microsoft MS-DOS operating system 3.3a
- Microsoft MS-DOS operating system 4.0
- Microsoft MS-DOS operating system 4.01
- Microsoft MS-DOS operating system 6.0
- Microsoft MS-DOS operating system 6.2
- Microsoft MS-DOS operating system 6.21
- Microsoft MS-DOS operating system 6.22
This article was previously published under Q70749 SUMMARY
The UNASSEMBLE command in the Debug utility has the syntax "U [range]" and
is used to display the unassembled information contained in the specified
range. For example, the command "U 0 8" displays the unassembled
information in bytes 0 (zero) through 8.
The command displays incorrect results if the specified range is bytes 0
through FFFF. DEBUG displays only the unassembled representation of the
byte at offset 0, rather than the bytes 0 through FFFF.
Modification Type: | Major | Last Reviewed: | 5/12/2003 |
---|
Keywords: | KB70749 |
---|
|