Windows Err Msg: Cannot Run Windows in Standard Mode (LANMAN) (69185)
The information in this article applies to:
- Microsoft Windows 3.0
- Microsoft Windows 3.0a
This article was previously published under Q69185 SYMPTOMS
If you load EMM386.SYS in the CONFIG.SYS file, run Microsoft LAN
Manager version 2.0 enhanced as your network, and try to start
Microsoft Windows version 3.0 with the WIN /S switch, you may get
the following error message:
Cannot run Windows in Standard Mode. Check to ensure you are not
running other protected-mode software, or run in real mode.
WORKAROUND
To allow standard mode to run, do one of the following:
- Remove or comment out the line in the [workstation] section of
your LANMAN.INI file that reads
LIM=YES
-or-
- Make a boot disk with a CONFIG.SYS file that does not load EMM386.SYS
if you want to use standard mode.
Modification Type: | Minor | Last Reviewed: | 7/7/2005 |
---|
Keywords: | KB69185 |
---|
|