Insufficent Memory to Run Toolbook Application (62871)
The information in this article applies to:
This article was previously published under Q62871 SYMPTOMS
If you manually copied the compressed files located on the Run-Time
ToolBook Setup Disk onto your hard disk, you may receive the error
"Insufficient Memory to Run Application" when trying to click the
following files in the TOOLBOOK directory:
TBOOK.EXE
DAYBOOK.TBK
DBHELP.TBK
TOURBOOK.TBK
WORKAROUND
If you must set up DayBook by manually copying the files to the hard
drive, you must first decompress the files with the Windows EXPAND.EXE
program. This can be accomplished by doing the following:
- Place the Windows 3.0 Disk 2 into Drive A. From the MS-DOS prompt, type
A:, then press ENTER.
- Type COPY EXPAND.EXE C:\. This
copies the EXPAND.EXE file to the root of Drive C.
- Create a backup copy of the ToolBook disk(s), and delete the files
TBKSETUP.EXE and TBKSETUP.INF from this backup.
- Place the backup of the ToolBook Setup Disk into Drive A and type
the following:
EXPAND A: *.* C:\TOOLBOOK
NOTE: This step requires that you have already created the TOOLBOOK
directory on Drive C.
- When all the files have been successfully decompressed and copied
to Drive C, associate the file DAYBOOK.TBK with ToolBook. Page 135
of the "Microsoft Windows User's Guide" describes how to associate
files with applications.
The above steps does not create the icons or the group for the DayBook
application or the Introduction to ToolBook application. This can be
done by following the instructions listed on Pages 87-91 of the
"Microsoft Windows User's Guide."
Modification Type: | Minor | Last Reviewed: | 7/7/2005 |
---|
Keywords: | KB62871 |
---|
|