Mac Hyp: Removing or Clearing a Message Field (62280)
The information in this article applies to:
- Microsoft Mail Software Development Kit (SDK) for HyperCard 2.0
- Microsoft Mail Software Development Kit (SDK) for HyperCard 3.0
This article was previously published under Q62280 SUMMARY
The msmail call "RemoveField" removes the occurrence of the field
indicated by "index" with the given "ident", as follows:
msmail(RemoveField, messageRef, ident [, index])
"ident" is a 4-character identification for that field.
If no "index" is specified, the first field with the specified "ident"
will be removed. An "index" of negative one (-1) removes all fields
with the specified ident.
Note: In Microsoft Mail version 2.00, the "index" parameter should
occur in the range between 0 and n-1, where "n" is the number of
fields. In Mail version 3.00, the parameter should occur in the range
from 1 to n.
MORE INFORMATION
The AddField command can add text to a pre-existing field or create a
new (unseen) field to hold the text. RemoveField clears fields that
are defined as part of the form, and removes fields that were created
with AddField. This function works only on messages that have not been
sent.
This information is taken from the "Microsoft Mail HyperCard Interface
Documentation."
Modification Type: | Major | Last Reviewed: | 10/2/2003 |
---|
Keywords: | KB62280 |
---|
|