XCON: Admin and Routing Group Are Displayed as "Unknown" After You Rename Them (327787)
The information in this article applies to:
- Microsoft Exchange 2000 Server
This article was previously published under Q327787 SYMPTOMS After you rename the Admin group or the Routing group (or
both), the Connected Routing Groups information may display the routing group
as "unknown." Therefore, mail destined to this routing group through an X400
Connector may not transfer, and this mail may back up in the X400 Pending
Routing queue.
In this case, you may have to manually reconfigure the
Connected Routing Group on the X400 Connector to select the new Admin group
name or Routing group name. RESOLUTION To resolve this issue, reselect the new name of the routing
group on the Connected Routing Groups tab to allow mail to
again flow properly. To do this, follow these steps: - Click Start, point to
Programs, point to Microsoft Exchange, and
then click System Manager.
- Expand Administrative Groups, expand
First Administrative Group, expand Routing
Groups, and then expand the routing group that contains the
non-functioning X400 Connector.
- Expand the Connectors container,
right-click the connector to be changed, and then click
Properties.
- Click the Connected Routing Groups tab,
and then make sure that the correct connected routing group is listed. Click
Modify, and then reselect the connected routing group (if it
is no longer selected).
- Click OK to save these changes.
STATUS Microsoft
has confirmed that this is a problem in the Microsoft products that are listed
at the beginning of this article.
| Modification Type: | Minor | Last Reviewed: | 4/25/2005 |
|---|
| Keywords: | kbbug KB327787 |
|---|
|