Automap: Some Data Is Not Displayed After Being Imported into Pushpins (299052)
The information in this article applies to:
This article was previously published under Q299052 SYMPTOMS
After you import data into pushpins in Microsoft MapPoint, some of the data may not be displayed as expected.
CAUSE
This behavior can occur if the data consists of more than 1,000 characters.
MORE INFORMATION
A pushpin can hold only 1,000 characters. After you reach this limit, the data is truncated, and any fields that do not fit are not displayed.
Character limit is set based on the balloon, not the field. For example, there is no restriction on the field size, only on the total number of characters supported in the balloon. The character limit for a balloon is approximately 4,000.
Modification Type: | Major | Last Reviewed: | 9/14/2001 |
---|
Keywords: | kbprb KB299052 |
---|
|