Visio2002: Error Message: "Error 1925. You Do Not Have Sufficient Privileges" Performing Setup with the /J Switch on NT 4.0 (293956)

The information in this article applies to:

Microsoft Visio 2002 Standard
Microsoft Visio 2002 Professional
Microsoft Windows NT Workstation 4.0 SP6
Microsoft Windows NT Workstation 4.0 SP6a
Microsoft Windows NT Server 4.0 SP6
Microsoft Windows NT Server 4.0 SP6a

This article was previously published under Q293956

SYMPTOMS

When you install Microsoft Visio 2002 using the /j command-line switch, you receive the following error message:

Error 1925. You do not have sufficient privileges to complete this installation for all users of the machine. Log on as administrator and then retry this installation.

NOTE: You receive this message even though you are logged on as administrator.

CAUSE

This issue may occur if you are installing Visio 2002 on a computer using the Microsoft Windows NT 4.0 operating system.

RESOLUTION

To work around this issue, install Visio without using the /j switch on the computer that is using Windows NT 4.0.

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.

MORE INFORMATION

For additional information about Setup command-line switches, click the article number below to view the article in the Microsoft Knowledge Base:

282119 Visio2002: Setup Command-Line Switches for Visio 2002

Modification Type:	Minor	Last Reviewed:	7/27/2006
Keywords:	kbprb KB293956