PRJ2000: Microsoft Project 2000 Stops Responding When You Save Project in Microsoft Project 98 Format (285682)



The information in this article applies to:

  • Microsoft Project 2000

This article was previously published under Q285682

SYMPTOMS

In Microsoft Project 2000, when you save a project in Microsoft Project 98 format, Microsoft Project may stop responding unexpectedly, or you may receive one of the following error messages, depending on your operating system:

Microsoft Windows 2000

Microsoft Project 2000 stops responding unexpectedly.

Microsoft Windows NT 4.0

You receive the following error message:
An application error has occurred and an application error log is being generated.

WINPROJ.exe
Exception: access violation (0x0000005), Address: address

Microsoft Windows Millennium Edition

You receive the following error message:
Winproj has caused an error in WINPROJ.EXE.
Winproj will now close.

If you continue to experience problems, try restarting your computer.

Microsoft Windows 98

You receive the following error message:
This program has performed an illegal operation and will be shut down.

If this problem persists, contact the program vendor.
If you click Details, you see the following:
WINPROJ caused an invalid page fault in module SERCONV.DLL at address.

CAUSE

This problem occurs when the project that you are saving from Microsoft Project 2000 contains custom bar formatting or custom cell formatting that exceeds the custom formatting limits for Microsoft Project 98.

RESOLUTION

To resolve this problem, obtain Microsoft Project 2000, Service Release 1 (SR-1).

To obtain SR-1, click the article number below to view the article in the Microsoft Knowledge Base:

288953 PRJ2000: How to Obtain and Install Microsoft Project 2000 SR-1

NOTE: To ensure that you can successfully open your project in Microsoft Project 98, Microsoft Project 2000 SR-1 only exports custom bar formatting or custom cell formatting up to a maximum number that is less than the actual limit allowed by Microsoft Project 98. When this number is reached, the custom formatting for remaining bars or cells will not be exported.

To temporarily work around this problem, remove some or all custom formatting before you try to save to the Microsoft Project 98 format. To remove all custom bar formatting or custom cell formatting, follow these steps.

NOTE: If you applied custom formatting to more than one view in the project, you must follow these steps for each view.
  1. Make sure that all tasks are visible in the view. To do this, follow these steps:
    1. Turn off autofiltering, if it is on. To do this, point to Filtered for on the Project menu, and then click AutoFilter.
    2. Apply the All Tasks filter. To do this, point to Filtered for on the Project menu, and then click All Tasks.
    3. Expand all subtasks. To do this, point to Outline on the Project menu, point to Show, and then click All Subtasks.
  2. Select all tasks. To do this, click the Select Table button (the blank gray button in the upper-left corner of the table portion of the view).
  3. To remove all custom cell formatting, point to Clear on the Edit menu, and then click Formats.
  4. To remove all custom bar formatting, click Bar on the Format menu, and then click Reset in the Format Bar dialog box.

STATUS

Microsoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article. This problem was corrected in Microsoft Project 2000, Service Release 1 (SR-1).

MORE INFORMATION

For a comparison of custom formatting limits and other feature capacities in versions of Microsoft Project, click the article number below to view the article in the Microsoft Knowledge Base:

86346 PRJ: Differences in Feature Capacities for Microsoft Project 1.x - 2000


Modification Type:MajorLast Reviewed:11/6/2002
Keywords:kbbug KB285682