How to Uninstall the Cluster Service on a Windows Server 2003 Cluster (282227)



The information in this article applies to:

  • Microsoft Windows Server 2003, Enterprise Edition
  • Microsoft Windows Server 2003, Datacenter Edition

This article was previously published under Q282227

SUMMARY

This article describes how to remove the Cluster service on a Windows Server 2003-based cluster.

MORE INFORMATION

The files for the Cluster service are installed, by default, on computers that run either Windows Server 2003, Enterprise Edition or Windows Server 2003, Datacenter Edition. In earlier versions of Windows, this feature had been in the Add/Remove Programs tool.

You cannot remove the Cluster service, but you can return it to an unconfigured state:
  1. Start Cluster Administrator (CluAdmin.exe).
  2. Right-click the node, and then click Stop the Cluster service.

    Note: Do not perform this step if this server is the last node in the cluster.
  3. Right-click the node, and then click Evict Node.

    This step returns the cluster to its original unconfigured state. You can re-add it later to the same or to a different cluster.
If you cannot start the Cluster service, or if you have trouble removing the node, you can manually unconfigure the Cluster service:
  1. Run the Cmd.exe program to open a command prompt.
  2. At the command prompt, type cluster node nodename /forcecleanup, and then press ENTER.

    Note: If the Cluster service does not exist in the registry, the command does not respond. To create a place holder, type the following line at the command line, and then press ENTER:

    sc create clussvc


Modification Type:MajorLast Reviewed:4/23/2004
Keywords:kbClustering kbhowto kbenv kbinfo KB282227