Cluster Configure Application Wizard Does Not Recognize Existing IP Addresses (282006)
The information in this article applies to:
- Microsoft Windows 2000 Advanced Server
- Microsoft Windows 2000 Datacenter Server
This article was previously published under Q282006 SYMPTOMS
If there is a pre-existing IP address resource, but no Network Name resource in a group, when you run the Configure Application Wizard, you receive the following error message:
An error occurred attempting to set private properties on the <GroupName>
The Cluster IP Address is already in use.
Error ID: 5057 (000013c1)
Your only option is to create a new IP address resource with a different IP address.
RESOLUTION
The Configure Application Wizard is designed to create an IP address resource to use in association with a Network Name resource. It does not give you the ability to use an existing IP resource.
You can either use the Configure Application Wizard to create a new IP address resource, or you can perform the desired tasks by manually creating the resources.
STATUS
This behavior is by design.
Modification Type: | Minor | Last Reviewed: | 1/26/2006 |
---|
Keywords: | kbbug kbnetwork KB282006 |
---|
|