XADM: Error c10361df Occurs When Installing Active Directory Connector (279748)
The information in this article applies to:
- Microsoft Exchange 2000 Server
This article was previously published under Q279748 SYMPTOMS
When you install Active Directory Connector (ADC) when you are logged on as an account in a mixed mode child domain, you may receive the following error message:
You must be a member of the Enterprise Administrator group to run Microsoft Active Directory Connector Setup.
ID no: c10361df
Microsoft Active Directory Connector Setup
CAUSE
This issue can occur if the account that you are logged on as is not a member of the Enterprise Administrator group.
RESOLUTIONNOTE: When this article refers to "native mode," it is referring to a Windows 2000 domain in native mode, not an Exchange 2000 organization in native mode.
To resolve this issue, install ADC in the child domain by using either of the following methods: - Install ADC on a computer in the child domain by logging on to the computer using an account in the root domain that is a member of the Enterprise Administrator group.
-or- - Convert the root and child domains to native mode. The account in the child domain can then be added to the Enterprise Administrator group. Before you making this change, be sure you have taken the necessary steps to prepare your domains for the transition to native mode. You cannot reverse changes to the domains after they are converted to native mode.
For additional information, click the article number below
to view the article in the Microsoft Knowledge Base:
231273 Group Type and Scope Usage in Windows 2000
After you install ADC, you can use an account in the child domain to administer ADC even if it is not a member of the Enterprise Administrator group.
Modification Type: | Minor | Last Reviewed: | 4/25/2005 |
---|
Keywords: | kbActiveDirectory kberrmsg kbprb KB279748 |
---|
|