NBA2000 Error Message: Invalid Page Fault in Module NBA2000.icd (275438)
The information in this article applies to:
- Microsoft NBA Inside Drive 2000 1.0
This article was previously published under Q275438 SYMPTOMS
When you attempt to start Microsoft NBA Inside Drive 2000, you may receive
an error message similar to the following:
- NBA2000 caused an invalid page fault in module NBA2000.icd.
- NBA2000 caused an invalid page fault in module NBA2000.exe.
CAUSE
This behavior can occur if one or more of the following conditions
are true:
- Your monitor is configured improperly.
- Your monitor or video adapter does not support a screen resolution
of 800 x 600 pixels.
- The video driver for your video adapter is outdated.
- Insufficient video memory is installed on your video adapter.
RESOLUTION
To resolve this issue, use the following methods in the order in which
they are presented.
Configure Your Monitor- Click Start, point to Settings, and then
click Control Panel.
- Double-click Display.
- Follow the appropriate steps for your version of Microsoft
Windows:
Microsoft Windows 95- On the Settings tab, click Change Display
Type.
- Under Monitor Type, note the manufacturer and model
of your current monitor. If an incorrect monitor, Default
Monitor, or Unknown Monitor is displayed in the
dialog box, click Change.
- Click Show All Devices.
Microsoft Windows 95 OEM Service Release 2 (OSR2)- On the Settings tab, click Advanced
Properties.
- On the Monitor tab, note the manufacturer and model
of your current monitor. If an incorrect monitor, Default
Monitor, or Unknown Monitor is displayed in the
dialog box, click Change.
- Click Show All Devices.
Microsoft Windows 98- On the Settings tab, click Advanced.
- Click the Monitor tab.
- Click to select the Automatically detect Plug
& Play monitors check box.
- Note the manufacturer and model of your current
monitor. If an incorrect monitor, Default Monitor,
or Unknown Monitor is displayed in the dialog box,
click Change.
- Click Next.
- Click Display a list of all the drivers in
a specific location, so you can select the driver you want,
and then click Next.
- Click Show all hardware.
- In the Manufacturers box, click the manufacturer of
your monitor.
- In the Models box, click the model of your monitor,
and then click OK, or click Next, click Next
again, and then click Finish.
NOTE: If you are prompted to verify that you want to
change the monitor, click Yes. - Click Close, and then click Close again.
Install an Updated Video Driver
To determine the manufacturer and the model of your video adapter:
- Click Start, point to Settings, and then
click Control Panel.
- Double-click System.
- Click the Device Manager tab.
- Double-click Display adapters.
In the branch under Display adapters, note
the manufacturer and the model of your video adapter. - Close Control Panel.
For information about how to contact the manufacturer of your video adapter, click the appropriate article number in the following list to view the article in the Microsoft Knowledge Base: 65416 Hardware and Software Third-Party Vendor Contact List, A-K
60781 Hardware and Software Third-Party Vendor Contact List, L-P
60782 Hardware and Software Third-Party Vendor Contact List, Q-Z Verify That Your Video Adapter Meets Minimum Hardware Requirements
Verify that your video adapter meets the minimum requirement of 2
megabytes (MB) of video memory. To determine the amount of video memory
that is installed on your video adapter, use the DirectX Diagnostic
Tool:
- Click Start, and then click Run.
- In the Open box, type the following line (including the
quotation marks), and then click OK
"drive:\program files\directx\setup\dxdiag.exe"
where drive is the drive letter of the hard disk
on which Microsoft Windows is installed. - Click the Display or Display 1 tab.
- Note the amount of video memory on the Approx.
Total Memory line under Device, and then
click Exit.
If less than 2 MB of video memory is installed on your video adapter,
install additional video memory on your video adapter, or install a video
adapter with more video memory.
Modification Type: | Major | Last Reviewed: | 8/6/2002 |
---|
Keywords: | KB275438 |
---|
|