BUG: Transform() Results Formatted Incorrectly (247494)


The information in this article applies to:

  • Microsoft Visual FoxPro for Windows 6.0
This article was previously published under Q247494

SYMPTOMS

You might see that the results of the TRANSFORM() function appear off by approximately .0000000000001. This behavior may occur when COMPATIBLE is OFF. However, when COMPATIBLE is ON, the expected behavior is observed.

RESOLUTION

Workaround

Here are three ways to work around this behavior:
  • Use this code: 
    SET COMPATIBLE ON
    -or-
  • Use this code: 
    ALLTRIM(STR(<nExpr>, <nLength>, <nDecimalPlaces>))
    -or-
  • Use this code: 
    SET DECIMALS TO <nDecimalPlaces>
SET FIXED ON
NOTE: Setting the nDecimalPlaces to >= 15 for any work around results in an overflow error.

STATUS

Microsoft has confirmed that this is a bug in the Microsoft products that are listed at the beginning of this article.

MORE INFORMATION

The TRANSFORM function was modified to allow the developer to issue Transform(<nExpr>) without a format or picture clause. The result is similar to ALLTRIM(STR(<nExpr>, <nLength>, <nDecimalPlaces>)).

How to Reproduce the Behavior

Enter the following code in a program and run the program: 
CLEAR
cCompatible = SET("COMPATIBLE")
SET COMPATIBLE OFF
? "Precision automatically jumps to 15 decimal places "
? "with overflows displayed at 1.6"

FOR i = 1 TO 3 STEP .1
	? TRANSFORM(i)
ENDFOR
SET COMPATIBLE &cCompatible
The values should begin to miscalculate around the number 1.6.
Modification Type:MajorLast Reviewed:10/15/2002
Keywords:kbBug kbCodeSnippet kbDSupport kbXBase KB247494 kbAudDeveloper
©2002 Microsoft Corporation. All rights reserved.