WD2000: Drawing Object/AutoShape Fill Pattern Appears As Shading (211509)
The information in this article applies to:
This article was previously published under Q211509 SYMPTOMS
When you print a document that contains a drawing object or an AutoShape
filled with a pattern, the pattern is printed smaller than expected and may
appear to be shading rather than a pattern.
NOTE: This problem may occur when you print to a PCL or a PostScript
printer.
WORKAROUND
Use the following steps to decrease the printer resolution when you print
the document:
- Open the document containing the filled pattern drawing or AutoShape object.
- On the File menu, click Print.
- In the Print dialog box, click Properties.
- Click the Graphics tab.
- Change the Resolution box to a lower value; for example, change it to
150 dots per inch, and then click OK.
- Click OK to close the Print dialog box and to print the document.
STATUSMicrosoft has confirmed that this is a problem in the Microsoft products that are listed at the beginning of this article.
Modification Type: | Major | Last Reviewed: | 9/7/2001 |
---|
Keywords: | kbbug kbprint kbusage KB211509 |
---|
|