PPT2000: Dragging Sizing Handle Doesn't Increase Height of Callout (197700)
The information in this article applies to:
- Microsoft PowerPoint 2000
This article was previously published under Q197700 SUMMARY
When you attempt to increase the height of an AutoShape, the AutoShape
moves up or down on the page and its height is not increased. This behavior
does not occur when you attempt to increase its width.
This behavior occurs because the "Resize AutoShape to fit text" option is
selected. When this option is selected, you can increase the height of the
AutoShape only by entering text in the callout.
To resize the AutoShape by dragging a resizing handle, turn off the "Resize
AutoShape to fit text" option, following these steps:
- Select the AutoShape.
- On the Format menu, click AutoShape.
- Click the Text Box tab.
- Click to clear the "Resize AutoShape to fit text" check box.
- Click OK.
You can now increase the height of the callout by dragging a resizing
handle.
Modification Type: | Major | Last Reviewed: | 11/30/2000 |
---|
Keywords: | kbhowto kbinfo KB197700 |
---|
|