Invalid Page Fault When You Try to Run the Registration Wizard (194904)
The information in this article applies to:
This article was previously published under Q194904
If this article does not describe the error message that you are receiving, view the following Microsoft Knowledge Base article to view more articles that describe error messages: 315854 Windows 98 and Windows Me Error Message Resource Center
SYMPTOMS
When you try to run the Microsoft Windows 98 Registration wizard, you may
receive the following error message, or one similar to it:
This program has performed an illegal operation and will be shut down.
If the problem persists, contact the program vendor.
REGWIZ caused an invalid page fault in module REGWIZC.DLL at
0257:10014da0.
CAUSE
This issue can occur if your installation of Microsoft WebTV for Windows
is damaged.
RESOLUTION
To resolve this issue, uninstall and then reinstall WebTV for Windows
before you run the Windows 98 Registration wizard. To do so, use the
following steps:
- Click Start, point to Settings, click Control Panel, and then
double-click Add/Remove Programs.
- Click the Windows Setup tab, click the WebTV for Windows check box to
clear it, and then click OK.
- Restart your computer.
- Click Start, point to Settings, click Control Panel, and then
double-click Add/Remove Programs.
- Click the Windows Setup tab, click the WebTV for Windows check box to
select it, and then click OK.
- Restart your computer. If you want to run the Registration wizard now,
click Start, click Run, type "regwiz /r" (without quotation marks) in
the Open box, and then click OK.
| Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
|---|
| Keywords: | kbenv kberrmsg kbInvalidPageFault kbprb KB194904 |
|---|
|