XFOR: Removing Connectors After Applying Exchange 5.5 SP1 (190236)


The information in this article applies to:

  • Microsoft Exchange Server 5.5 SP1
This article was previously published under Q190236

SYMPTOMS

After you install Exchange Server 5.5 SP1, you cannot perform a "Remove All" to uninstall connectors that were previously installed by the Exchange Connectivity Setup application. Performing a "Remove All" does not remove the connector files. The Notes, SNADS, and OfficeVision/VM connectors are the only connectors affected by this behavior.

WORKAROUND

The Exchange connectors for Notes, SNADS, and OfficeVision/VM included in the Microsoft Exchange Connectivity package are installed from the Exchange Server 5.5 CD \Server\Exchconn directory. The connectors are updated from \Exchconn directories on the Exchange Server 5.5 Service Pack 1 CD.

To uninstall any of these connectors from an Exchange Server computer, perform the following steps:
  1. Click Start, click Programs, and then click Microsoft Exchange Connectivity. Click Setup.
  2. On the Exchange Connectivity Setup application, select Uninstall Microsoft Exchange Connectivity Software, and then follow the instructions provided.
Modification Type:MinorLast Reviewed:4/28/2005
Keywords:kbbug kbnofix KB190236
©2004 Microsoft Corporation. All rights reserved.