Unable to Access CD-ROM Drive After Installing Windows 98/Me (189526)
The information in this article applies to:
- Microsoft Windows Millennium Edition
- Microsoft Windows 98 Second Edition
- Microsoft Windows 98
This article was previously published under Q189526 SYMPTOMS
After you install Windows 98 or Windows Millennium Edition (Me), you may be unable to access your CD-ROM drive.
CAUSE
This behavior can occur if you have a dual-channel integrated device
electronics (IDE) controller installed in your computer.
RESOLUTION
To work around this behavior, follow these steps:
- Click Start, point to Settings, click Control Panel, and then double-click System.
- Click the Device Manager tab.
- Click the Hard Disk Controllers branch to expand it, click your IDE
controller, and then click Properties.
- Click the Settings tab.
- In the Dual IDE Channel Settings box, click Both IDE Channels Enabled,
and then click OK.
- Click OK, and then restart your computer.
- Test to determine if the issue is resolved by trying to use your CD-ROM drive. If the issue is not resolved in Windows 98, perform the troubleshooting steps in the following article by clicking the article number below
to view the article in the Microsoft Knowledge Base:
190303 How to Use Real-Mode CD-ROM Drivers from Windows 98 Startup Disk
Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
---|
Keywords: | kbHardware kbprb KB189526 |
---|
|