Small Business Server Setup Should Only Detect a Single Netcard (189074)
The information in this article applies to:
- Microsoft BackOffice Small Business Server 4.0a
- Microsoft BackOffice Small Business Server 4.0
This article was previously published under Q189074 SYMPTOMS
Small Business Server Setup will set an IP address for the first detected
netcard but will then stop and wait for a customer supplied IP address for
the second netcard, when bindings are being performed for Modem Sharing and
the Microsoft TCP/IP Properties dialog box is displayed and waits for user
input.
CAUSE
Small Business Server is configured through Winnt.sif to detect and
install the first card detected by Netdetect.
RESOLUTION
It is possible to "Cancel" at this screen and not have any ill effect on
server operation because the first netcard is fully configured. After Small
Business Server has finished installing, the second netcard can be
configured correctly by going to the Network tool in Control Panel.
STATUS
Microsoft has confirmed this to be a problem in Microsoft BackOffice Small
Business Server. We are researching this bug and will post new information
here in the Microsoft Knowledge Base as it becomes available.
Modification Type: | Major | Last Reviewed: | 2/24/2004 |
---|
Keywords: | kbbug kbnofix KB189074 |
---|
|