HyperTerminal Is Not Installed By Default in Windows 98 (186939)
The information in this article applies to:
This article was previously published under Q186939 SYMPTOMS
After you choose Typical Install and perform a clean install of Windows 98
to a new folder or hard disk, you may notice that the HyperTerminal
program is not installed.
RESOLUTION
To resolve this problem, manually install HyperTerminal. To do so, use the
following steps:
- Click Start, point to Settings, click Control Panel, and then
double-click Add/Remove Programs.
- Click the Windows Setup tab, click Communications (the word, not the
check box), and then click Details.
- Click the HyperTerminal check box to select it, and then click OK.
- Click OK, and then follow the instructions on the screen to complete
the installation.
MORE INFORMATION
When you upgrade to Windows 98 with HyperTerminal installed, HyperTerminal
is still installed and functional.
Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
---|
Keywords: | kbprb KB186939 |
---|
|