Error 204: Terminal Server Client TCP Port error (186617)
The information in this article applies to:
- Microsoft Windows NT Server 4.0 Terminal Server Edition
This article was previously published under Q186617 SYMPTOMS
When you try to connect to a Beta 2 Terminal Server using the Terminal
Server Client, you may get a "Failure to connect: 204" error. The cause of
this error is most likely that you are using a pre-Beta 2 version of the
client. A change was made in Terminal Server so that it listens for traffic
on port 3389, rather than on port 1503, as in pre-Beta 2 versions.
RESOLUTION
You can verify that this is the cause of your connection problem by
capturing the network traffic with Network Monitor (included with Terminal
Server) as you attempt to connect. After stopping the trace, the summary
view screen will show the client attempting to connect. You should see the
source port number (src:) and the destination port number (dst:3389) in the
description field.
Uninstall any client versions prior to Beta 2, and install the new version.
If this is not the problem, the 204 error points to a TCP port problem. It
means that the initial socket connection between the Terminal Server and
the client could not be established. You might have a protocol problem on
the client computer, particularly with Windows for Workgroups 3.11 clients.
Be sure you are using the TCP/IP-32B version from the Clients subdirectory
on the Terminal Server CD. For Windows 95 or Windows NT Clients, try
reinstalling the TCP/IP protocol. Third, you could have a protocol problem
on the Terminal Server. Reboot the server and then, if this doesn't resolve
the problem, reinstall the TCP/IP protocol on the server.
Modification Type: | Minor | Last Reviewed: | 7/13/2004 |
---|
Keywords: | kbprb KB186617 |
---|
|