ScanDisk Portion of Windows 98 Setup Takes a Long Time (185659)
The information in this article applies to:
This article was previously published under Q185659 SYMPTOMS
When you run Windows 98 Setup from within Windows, the ScanDisk portion of
Setup may take an unusually long time to check your hard disks. NOTE: To more effectively search the Microsoft Knowledge Base, use keywords that relate to your issue. If you are searching for troubleshooting information that is not mentioned in this article, search the Microsoft Knowledge Base again by using keywords that are listed in the following Microsoft Knowledge Base article: 242450 How to Query the Microsoft Knowledge Base Using Keywords CAUSE
This issue can occur if you are loading the DosIdle version 2.00 program in your Autoexec.bat file.
RESOLUTION
To resolve this issue, disable DosIdle before you install Windows 98:
- Restart your computer, press and hold the CTRL key until you see the
Windows 98 Startup menu, and then choose Command Prompt Only.
- At the command prompt, type edit autoexec.bat, and then press ENTER.
- Disable the line that loads the Dosidle.exe file. To do so, type rem and then press the SPACEBAR at the beginning of the line.
- Press ALT+F, press S (to save), press ALT+F, and then press X (to exit).
- Restart your computer normally, and then run Windows 98 Setup.
MORE INFORMATION
DosIdle 2.00 is a freeware program that is included with CpuIdle for Windows 95/98, and is designed to take advantage of power management features of your computer's BIOS.
The third-party products that are discussed in this article are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products.
Modification Type: | Minor | Last Reviewed: | 12/16/2004 |
---|
Keywords: | kb3rdparty kbprb kbsetup KB185659 |
---|
|