WD98: Document Margins Not Retained When Inserted as File (182338)


The information in this article applies to:

  • Microsoft Word 98 Macintosh Edition
This article was previously published under Q182338

SYMPTOMS

When you insert one document (source) into another document (destination) that contains different formatting, the formatting of the source document takes on the formatting of the destination document. Document layout formatting (such as margin settings, headers and footers, and page orientation) take on the formatting of the destination document, even when you insert a section break before you insert the source document.

WORKAROUND

Insert your source document as a subdocument in a master document using either of the following methods.

Method 1: If the Source Document Does Not Contain Headers or Footers

  1. In the document that you want to insert a file (destination document), click Master Document on the View menu.
  2. Place the insertion point where you want to insert your file and then on the Master Document toolbar, click the Insert Subdocument button.
  3. Select your file to be inserted (source document), and then click Open.

    NOTE: When you insert the subdocument (source document) into the master document, Word adds a continuous section break above and below the subdocument. Also, if the master document contains headers and footers, then the inserted document will obtain the master documents headers and footers.
The source document now retains its formatting when you insert it into the destination document.

Method 2: If the Source Document Contains Headers or Footers

  1. On the Insert menu, click Break.
  2. Under Section Breaks, click Next Page and then click OK.

    NOTE: This will place a Section Break (Next Page) in your master (destination) document.
  3. Again, under Section Breaks, click Next Page and then click OK.

    NOTE: This will place a second Section Break (Next Page) in your master (destination) document.
  4. Move your insertion point back to the second Section Break (Next Page) and then on the View menu, click Header And Footer.
  5. On the Header And Footer toolbar, click the Same As Previous button to turn off "Same as Previous" in the header. Switch to the footer and turn off "Same as Previous" in the footer.
  6. Click Close to close the header and footer.
  7. With the insertion point on the second Section Break (Next Page), click the Insert Subdocument button on the Master Document toolbar.

    NOTE: Do not select the second Section Break (Next Page) before inserting your source document as the section break will be deleted when you insert your subdocument.
The source document now retains its formatting when you insert it into the destination document.

STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article.
Modification Type:MajorLast Reviewed:10/4/2002
Keywords:kbbug kblayout KB182338
©2002 Microsoft Corporation. All rights reserved.