XCON: Site Connector Address Spaces Do Not Appear in GWART When Sites Replicated (182128)
The information in this article applies to:
- Microsoft Exchange Server 4.0
- Microsoft Exchange Server 5.0
- Microsoft Exchange Server 5.5
This article was previously published under Q182128 SYMPTOMS
Address spaces that are added or modified on a site connector that connects
two replicated sites will not appear in the Gateway Address Routing Table
(GWART) or Site Addressing Routing list.
CAUSE
This is by design. Address spaces on a site connector are only used if the
sites being connected are not replicated. After the sites are replicated,
all of the address spaces on the site connector (except for Local/Subsite
restricted spaces) are ignored, and the remote site's replicated GWART is
used to define the address spaces that the remote site supports.
RESOLUTION
X.400 Connector address spaces are not limited by directory replication and
can be implemented in lieu of the site connector. The additional address
space can then be defined for the X.400 Connector.
Modification Type: | Minor | Last Reviewed: | 4/28/2005 |
---|
Keywords: | kbusage KB182128 |
---|
|