Start Button Not Disabled Using Snap-in Interface (180692)
The information in this article applies to:
This article was previously published under Q180692 SYMPTOMS
The following problem occurs when you use the SNA Server 4.0 snap-in
administrative interface to the Microsoft Management Console (MMC). If the
start button in SNA Server version 4.0 is used to start a service, the
start button will remain disabled after the service has been started. If
you use the mouse to click on another location and then back, the button
will reflect the correct status.
Starting an already started service leaves it pending indefinitely. The
same situation applies when stopping a service and when using the Save
Config button. This problem does not occur when you use the SNA Server 4.0
Manager interface.
STATUS
Microsoft has confirmed this to be a problem in SNA Server version 4.0.
This problem was corrected in the latest SNA Server version 4.0 U.S.
Service Pack. For information on obtaining this Service Pack, query on
the following word in the Microsoft Knowledge Base (without the spaces):
Modification Type: | Minor | Last Reviewed: | 9/22/2005 |
---|
Keywords: | kbHotfixServer kbQFE kbbug kbfix KB180692 |
---|
|