Using command-line switches with playlist files (176678)

MORE INFORMATION

Command lines should use the following format

   ppview32.exe [command-line switches] "<path\powerpnt file name>"
				

where <path\powerpnt file name> is the path and file name for the presentation you want to include in the playlist.

The following command-line switches are supported:

   Switch              Used for
   -------------------------------------------------------------------

   /A or /a            Automatic advance
   /R=n-m or /r=n-m    Slide range
   (where n<=m)
   /L or /l            Loop continuously
   /P or /p            Print, for printing file
   /K or /k            Kiosk password, for setting a kiosk mode for file
   /V or /v            For showing the macro virus dialog box
				

NOTE: The /v switch does not enable the use of macros, it simply enables a special dialog box to be displayed when opening other documents that might have macros enabled, such as a Word document.

Playlist files used with the Microsoft PowerPoint Viewer 97 do not recognize switches when opened at the command line. However, you can use command-line switches within the playlist file using the format below.

To apply a switch to individual files, use the following format:

   [switch] <path\filename>
   [switch] <path\filename>
   ...
   [switch] <path\filename>
				

The following example loops a presentation until ESC is pressed, and then moves to the next presentation and loops it:

   /L PRES1.PPT
   /L PRES2.PPT
   ...
   /L PRESx.PPT
				

To apply a switch across a group of files, use the following format:

   [switch] "<path\filename>" "<path\filename>" ... "<path\filename>"
				

The following example plays each presentation once, and then begins again after the last presentation has completed:

   /L "PRES1.PPT" "PRES2.PPT" ... "PRESx.PPT"
				

Not all command-line switches are available within playlist files. The following switches are supported within .LST files: /A, /R=N-M, /L, /K, and /V.