Cannot Undock Window in Visual Basic with ClickSaver Feature (176044)
The information in this article applies to:
- Microsoft IntelliPoint software 2.0
- Microsoft IntelliPoint software 2.0a
- Microsoft IntelliPoint software 2.1
This article was previously published under Q176044 SYMPTOMS
When you click a docked window in Microsoft Visual Basic 5.0 with the
ClickSaver feature enabled in the Mouse tool in Control Panel, the window
may not undock.
RESOLUTION
To resolve this issue, double-click the docked window.
If this does not undock the window, turn off the ClickSaver feature by
following these steps:
- Click Start, point to Settings, and then click Control Panel.
- Double-click Mouse.
- On the StepSavers tab, click the ClickSaver check box to clear it.
- Click OK.
STATUS
Microsoft is researching this problem and will post new information here
in the Microsoft Knowledge Base as it becomes available.
MORE INFORMATION
You can use the ClickSaver feature to click once where you normally double-click.
When you click an undocked window once in Visual Basic 5.0 with the
ClickSaver feature enabled, the window docks correctly.
Modification Type: | Major | Last Reviewed: | 12/17/1999 |
---|
Keywords: | kbui KB176044 |
---|
|