XFOR: Inbody addressing (166643)
The information in this article applies to:
- Microsoft Exchange Server 4.0
- Microsoft Exchange Server 5.0
- Microsoft Exchange Server 5.5
This article was previously published under Q166643 SUMMARY
The inbody (or ad hoc) addressing feature allows host senders to address
users that are not registered in the host or Microsoft Exchange Server
directory. The system administrator can disable this feature.
MORE INFORMATION
This inbody addressing feature is available on the host connector because
its 8x8 character address space, consisting of the DGN.DEN, limits the
addressing options from the host to other mail systems. For example, in
Lotus cc:Mail or Lotus Notes, a user can explicitly address using @smtp or
@notes or @ccmail.
Distribution Group Name (DGN) and Distribution Element Name (DEN) are
addressing components of a SNADS address. OV/VM addresses have the same
restrictions but are called nodeid(userid). DGN is similar to a postoffice
(or just a grouping of users); DEN is similar to a username.
In SNADS or OV/VM, the sender is limited to specifying the DGN (or nodeid)
and DEN (or userid) of the user. This DGN.DEN (or nodeid[userid])
combination uniquely identifies a user defined in the host address
directory. Because a fully qualified Lotus Notes, Lotus cc:Mail, or SMTP
address does not fit in the 8x8 character field, the sender can specify the
recipients in the body of the message. A keyword tells the connector where
the addresses begin and the blanks identify the end of recipient's
addresses. The default keyword is "subject:" (without the quotes). However,
this can be changed by assigning a value to the LASTMSGHEADER parameter in
the LME-SNADS section of the .ini file.
In the To field, the host user sends the message to DGN.DEN (or
nodeid[userid]) where DGN represents the Exchange Server computer and DEN
is the adhoc ID as specified in the .ini file in the LME section. In
LinkAge Message Exchange, the default adhoc ID is "linkage" (without the
quotes). In Exchange Server 5.5, an administrator has to enter an adhoc ID
because the default value is blank (hence, disabled).
To Disable Inbody Addressing
In Exchange Server 5.5:
Set the value of the ADHOCID parameter in the Exchconn.ini file
to a null string. Add the following line to the file:
ADHOCID =
In Exchange Server versions 4.0 and 5.0:
Set the value of the ADHOCID parameter in the Linkage.ini file
to a null string. Add the following line to the file:
ADHOCID =
To Enable Inbody Addressing
By default, inbody addressing is enabled in Exchange Server 4.0 and 5.0.
However, by default, it is not enabled in Exchange Server 5.5. To use this
feature in version 5.5, you must enable it.
Set the value of the ADHOCID parameter in the Exchconn.ini file
to the preferred value. For example, add one of the following lines to
the file:
ADHOCID = INTERNET
-or-
ADHOCID = INBODY
This behavior is by product design.
| Modification Type: | Minor | Last Reviewed: | 4/28/2005 |
|---|
| Keywords: | kbhowto KB166643 |
|---|
|