SNA 3.0 Setup Fails If Computer Name Starts with a Digit (165085)
The information in this article applies to:
This article was previously published under Q165085 SYMPTOMS
If you install SNA Server 3.0 on a computer whose name contains a number
as the first character, Setup completes successfully. However, when you
first run SNA Server Manager, no SNA Servers are listed in the Manager.
Also, if you close the Manager at that point, you will get a Dr. Watson
error in Snaexp.exe. However, the DrWtsn32.log file will not show a fault
(which would tell you which module actually caused the access violation).
CAUSE
This is a regression for a problem that was corrected in SNA Server 2.11
Service Pack 1.
RESOLUTION
To resolve this problem, obtain the hotfix mentioned below.
STATUS
Microsoft has confirmed this to be a problem in SNA Server version 3.0.
This problem was corrected in the latest Microsoft SNA Server 3.0 U.S.
Service Pack. For information on obtaining the service pack, query on
the following word in the Microsoft Knowledge Base (without the spaces):
| Modification Type: | Major | Last Reviewed: | 10/23/2003 |
|---|
| Keywords: | kbbug kbfix kbnetwork KB165085 |
|---|
|