Processor Reaches 100 Percent CPU Use When Printing (164793)

CAUSE

You will the see the following section of traces repeated infinitely in the Print Service internal trace:

00d5:00eb 13:32:48.0472 winvprtp.c(1167)   PCLOS Terminate job D93ECBC on
printer D93ECA8
00d5:00eb 13:32:48.0472 winvprtj.c(1747)   ENDJB Enter, idJob=0xD93ECBC
00d5:00eb 13:32:48.0472 winvprtp.c(187)    VLJOB Enter, id=0xD93ECBC
00d5:00eb 13:32:48.0472 winvprtp.c(232)    VLJOB Leave, pJob=0D93ECBC
00d5:00eb 13:32:48.0472 winvprtj.c(1677)   JTERM Enter, pJob = 0xD93ECBC,
fCancel=0
00d5:00eb 13:32:48.0472 winvprtj.c(1706)   JTERM ERROR EndDoc, rc=0x6
00d5:00eb 13:32:48.0472 winvprtj.c(1713)   JTERM Leave, rc=1
00d5:00eb 13:32:48.0472 winvprtj.c(1809)   ENDJB ERROR Invalid job
id=0xD93ECBC
00d5:00eb 13:32:48.0472 winvprtj.c(1842)   ENDJB Leave, rc=2
00d5:00eb 13:32:48.0472 winvprtp.c(1167)   PCLOS Terminate job D93ECBC on
printer D93ECA8
00d5:00eb 13:32:48.0472 winvprtj.c(1747)   ENDJB Enter, idJob=0xD93ECBC
				

PCLOS is the trace name for the WinVPRTClosePrinter function contained in Printsrv\Winvprt\Winvprtp.c. This function first attempts to end all active print jobs owned by the print session, and then end the print session itself. PCLOS contains the following code:

   /*********************************************************************/ 
   /* Search for active jobs on this print session                      */ 
   /*********************************************************************/ 
   while (pPrt->pJob)
   {
      TRACE4()"Terminate job %X on printer %X",pJob,pPrt));
      pJob = pPrt->pJob;
      WinVPRTEndJob(pJob->id, TRUE);
   }
				

This is the code that is looping because the "Terminate job xx on printer yy" is constantly repeated in the trace. Further, the job and printer control blocks traced (D93ECBC and D93ECA8) are the same every time.

The only way that this code can loop indefinitely is if pPrt->pJob is always a non-zero value. If you look into the WinVPRTEndJob function, you will see a call to another function called JobCleanup. The last thing that this code does is remove the terminating job control block (pPrt->pJob) from the 'linked list' of job control blocks owned by the printer control block (pPrt). The result should be one less job control block owned by the printer. The code shown above should then attempt to end the next job owned by the print session and so on, until there are no jobs left (when the last one is removed pPrt->pJob will go to zero).

However, this does not happen and the code loops indefinitely, trying (and failing) to end the same job every time.