SET: Screen Displays "Boot 2>" Prompt After First Setup Reboot (163400)
The information in this article applies to:
- Microsoft Windows NT Workstation 3.5
- Microsoft Windows NT Workstation 3.51
- Microsoft Windows NT Workstation 4.0
- Microsoft Windows NT Server 3.5
- Microsoft Windows NT Server 3.51
- Microsoft Windows NT Server 4.0
This article was previously published under Q163400 SYMPTOMS
When you perform a new install of Windows NT, the prompt "Boot 2>" is
displayed on the screen after the reboot from text setup to GUI setup.
CAUSE
This condition can occur if the product System Commander from V
Communications was previously installed on the target hard disk.
This error can also appear if the master boot record code is corrupted.
WORKAROUND
There are three ways to work around this problem:
- Low-level format the drive.
- Use the System Commander uninstall.
- After backing up the mbr using disksave.exe, run fdisk /mbr against the
system and the machine should get past this error.
STATUS
The third-party products discussed here are manufactured by vendors
independent of Microsoft; we make no warranty, implied or otherwise,
regarding these products' performance or reliability.
Modification Type: | Major | Last Reviewed: | 5/14/2003 |
---|
Keywords: | kb3rdparty kbsetup KB163400 |
---|
|