Proper Load Order of MCIS MIBS for Use with SNMP (156973)


The information in this article applies to:

  • Microsoft Commercial Internet System 1.0
This article was previously published under Q156973
The following list is the order that you should add MIBs to your SNMP management console to enable access to SNMP objects on Microsoft Commercial Internet System (MCIS) server nodes:

  1. Mib_ii.mibLmmib2.mibMssql.mibWins.mibDhcp.mibInetsrv.mibFtp.mibGopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  2. Lmmib2.mibMssql.mibWins.mibDhcp.mibInetsrv.mibFtp.mibGopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  3. Mssql.mibWins.mibDhcp.mibInetsrv.mibFtp.mibGopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  4. Wins.mibDhcp.mibInetsrv.mibFtp.mibGopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  5. Dhcp.mibInetsrv.mibFtp.mibGopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  6. Inetsrv.mibFtp.mibGopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  7. Ftp.mibGopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  8. Gopherd.mibHttp.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  9. Http.mibGateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  10. Gateway.mibPop3.mibSmtp.mibNntp.mibPerf2mib.mib
  11. Pop3.mibSmtp.mibNntp.mibPerf2mib.mib
  12. Smtp.mibNntp.mibPerf2mib.mib
  13. Nntp.mibPerf2mib.mib
  14. Perf2mib.mib
NOTE: For ITEM 14 you need to make sure you also run Perf2mib\Setup.bat on each system you want to poll with objects defined in this MIB. Afterwards all Microsoft specific entries will reside under the SNMP database branch:

iso.org.dod.internet.private.enterprises.microsoft.software

Modification Type:MajorLast Reviewed:9/30/2003
Keywords:KB156973
©2003 Microsoft Corporation. All rights reserved.