SYMPTOMS
When you are using NetMeeting and you try to connect or reconnect to a
Directory server using an Internet Locator server (ILS) or User Location
server (ULS), you may receive one or more of the following error messages:
The User Location Server could not be found. Your information will not
be available to others.
There was a problem connecting to the Directory Server. Please choose
another server.
You may be able to view the Directory server with your Web browser.
MORE INFORMATION
Determining If Your Directory Server Is Down
Try to ping the server. When you are connected to your ISP, type
ping name of the directory server at a command prompt, and then press ENTER, where
name of the directory server is the name of your directory server.
If you do not get a reply, the Directory server may be down, or your
Domain Name Service (DNS) configuration may be invalid.
If you get a reply, try using the Internet Protocol (IP) address as your
Directory server.
Determining If Your Connection Is 16-Bit or 32-Bit
When you are connected to your ISP, click
Start, click
Run, type
winipcfg, and then click
OK.
If the information displayed in the fields is all zeros when you are
connected to your ISP, you are probably using a 16-bit version of
Winsock.dll.
Check to see if your ISP can work properly with a 32-bit version of
Winsock.dll. If appropriate, upgrade to the 32-bit version. The Dial-Up
Networking tool included with Microsoft Windows 95, Microsoft Windows 98,
and Microsoft Windows NT 4.0 uses a 32-bit connection.
For additional information about how to connect to the Internet using the Dial-Up Networking tool, please see the following article(s) in the Microsoft Knowledge Base:
138789 How to Connect to the Internet in Windows 95/98
171015 How to Install and Configure Windows NT Dial-Up Networking
For additional information about the Winipcfg tool, please see the following article(s) in the Microsoft Knowledge Base:
141698 How to Use Winipcfg to View TCP/IP Settings
For additional information about old Winsock programs, please see the following article(s) in the Microsoft Knowledge Base:
139384 Programs Using Old Winsock.dll File May Not Work in Windows
Determining if the ILS/ULS ports are open
To determine whether the ILS/ULS ports are open to the ILS server, please see the following article(s) in the Microsoft Knowledge Base:
171648 Troubleshooting Connections in NetMeeting Using Telnet
Determining if ILS/ULS server is configured properly
If you cannot connect to an ILS/ULS server, please see the following article in the Microsoft Knowledge Base:
161643 NetMeeting Clients Can't Connect to Multihomed ILS
Proxy Configuration
For additional information about proxy configuration, please see the following article(s) in the Microsoft Knowledge Base:
158623 How to Establish NetMeeting Connections Through a Firewall
For another source on proxy configuration, see the NetMeeting Resource
Kit, Chapter 4, "Firewall Configuration." The NetMeeting Resource Kit is
available on the following Microsoft Web site:
Waiting After Closing NetMeeting
Your user name may remain listed as connected to the Directory server.
NetMeeting sends a termination message to the Directory server when
closing. This message notifies the server to remove your user name. This
process usually takes less than a minute. Because the server is receiving
Transmission Control Protocol/Internet Protocol (TCP/IP) information, it
may not recognize that NetMeeting has terminated. It is possible for your
user name to remain listed for five minutes or more.
Directory Server Standards (ULS and ILS) Supported in NetMeeting
NetMeeting 1.0 supports User Location Server (ULS) via User Locator
Protocol (ULP).
NetMeeting 2.0 and later supports the industry-standard Internet Locator
Server (ILS) via Lightweight Directory Access Protocol (LDAP). NetMeeting
2.0 and later also supports ULS for backward compatibility.
More Information About NetMeeting
For more information about NetMeeting, including how to obtain a list of public ILS servers, click the following link:
http://directory.netmeeting.microsoft.com/MoreInfo/nmMoreInfo.htm